Perfect measuring device, allows safe and easy dispensing. Fits any plastic bottle with a 28 millimeter cap thread (e.g. soda bottle).
Great addition to 16 fl oz bottles of FTC Decarbonizer and Marine Diesel Stabilizer. Adds a perfect measuring device to these bottles, and allows safe and easy dispensing! So easy to use! Accurate measuring! No mess dispensing!
-
Child-proof caps
-
Fully sealed – stays on the bottle till empty
-
Excess drips go back into the bottle
-
Measures in 5 milliliter increments up to 20 milliliters
-
Re-usable – only buy it once for each product
You only need to purchase EZYPOR once. It simply screws on and replaces the original bottle cap, and it seals just as the original cap would. The caps are child proof – both where it screws onto the bottle, and also on its own cap. Fit the EZYPOR device, and gently squeeze the bottle which fills up the clear plastic chamber in 5 milliliter increments up to 20 milliliters, allowing for a precise measure.
Remove the top child-proof cap. The extension nozzle pops up to enable easy pouring into small openings.
When you return the bottle to upright, any drips get trapped by the pop-up nozzle. When the cap is replaced, the nozzle pushes down and returns the drip to the reservoir.
* Note – If the bottle does not have a thread length of at least 1/2″ (13 millimeters), a leak can occur. In the picture, the bottle on the right hand side lacks adequate thread length and could possibly leak. To remedy this, it is recommended to use the supplied washer – place the washer inside the EZYPOR threaded section until it is snug against the bottom flat surface. Screw the EZYPOR tightly on to the bottle, and test again for air escaping as described above. Tighten as necessary.
Ensure the EZYPOR reservoir is 
